Shop
Showing 37–48 of 268 results
-
EARTH/GROUND RESISTANCE TESTER, CLAMP-ON GROUND RESISTANCE TESTER, Metravi
CET-01 Clamp On Ground Resistance Tester
-26%
EARTH/GROUND RESISTANCE TESTER, CLAMP-ON GROUND RESISTANCE TESTER, MetraviCET-01 Clamp On Ground Resistance Tester
- Display: 4 digit Backlit LCD
- Resistance Range: 0.01Ω to 1500Ω
- Resolution: 0.01 Ohms
- Auto Ranging
- Storage of Measured Data: 99 Data
- Setting of Resistance Alarm Critical Value: 1 – 199 Ohms
- Data Hold, Auto Power Off
- Instrument safety: IEC/EN61010-1, IEC/EN6010-2-032
- Auto Power Off: after 5 minutes of being idle
- Display: 4 digits 9999 counts Backlit LCD with annunciators
- Memory size: 99 Units of Reading
- Data upload interface: RS232 (Optional)
SKU: n/a -
CABLE FAULT LOCATOR, DIGITAL CABLE FAULT LOCATOR, Metravi
CFL-01 Cable Fault Locator with Pipe and Cable Tracer
-26%
CABLE FAULT LOCATOR, DIGITAL CABLE FAULT LOCATOR, MetraviCFL-01 Cable Fault Locator with Pipe and Cable Tracer
- Consists of a transmitter and a receiver
- Used to detect or trace conductors and to find short faults in them.
- Conductor tracing in the soil
- Detecting fuses and assigning current circuits
- Tracing sockets and distribution sockets having accidentally been covered by plastering
- Detecting interruptions and short-circuits in floor heating
- Tracing metallic water and heating piping
- Automatic and manual sensitivity adjustment
- Acoustic reception signal may be switched off
- Auto-Power-Off function
- Backlit LCD
SKU: n/a -
CABLE FAULT LOCATOR, DIGITAL CABLE FAULT LOCATOR, Metravi
CFL-02 Digital Cable Fault Locator
- Pin Points Fault in all underground cables.
- Useful for Power, Control & Telecom Cables
- Maximum Cable Length 5kms
- Accuracy ±5%
- Faults located can be Medium/High Resistance Faults, Open Circuit and Short Circuit faults
- Two Techniques used
- Potential Comparison Technique
- Capacitance Comparison Technique
SKU: n/a -
HANDHELD DEVICES, MULTIMETERS, Sonel
CMM-40 Multimeters
- MAX and MIN function for saving extreme values
- AC+DC function for reading the sum of an alternating and direct component
- REL mode for relative measurement to a stored reference value
- PEAK Hold for displaying the peak value of the measured parameter.
SKU: n/a -
HANDHELD DEVICES, MULTIMETERS, Sonel
CMM-60 Multimeters
- The automatic holding of the measurement result while working with both hands is now possible thanks to the AutoHold function,
- Measurements of the current loop 4-20 mA in analogue circuits controlling temperature, pressure, humidity or flow sensors are possible thanks to the special function that displays the percentage results for the corresponding current values,
- The meter allows the measurement of very small currents in the range of 500 μA, useful during service works, e.g. in tests of real-time clock support systems or in the maintenance of flame sensors in combustion chambers,
- Thanks to the dedicated “CMM-60 Multimeter Software”, it is possible to transfer results from the meter’s memory to a computer program and analyse these results further,
- Visibility in all conditions and reading at a wide angle are possible thanks to the colour display with a resolution of 320 x 240 pixels and a diagonal of 3.5”,
- Operating the meter in thick gloves during industrial measurements will not be a problem thanks to the specially designed rotary switch
SKU: n/a -
GAS DETECTORS & ANALYSERS, CARBON MONOXIDE DETECTOR, Metravi
CO-09 Carbon Monoxide Meter
- Max Hold and Data Hold
- Backlit LCD Display
- Range : 0 – 1000PPM
- Resolution : 1PPM
- Accuracy : ±5% or ±10PPM
- Auto/Manual Zero
- Warm up period: 10 seconds
- Sensor Type : Stabilised electrochemical Gas-specific (CO)
- Auto Power Off
- High accuracy, quick response
- Pocket-sized
SKU: n/a -
Data Loggers, Novus
Data logger Wi-Fi LogBox Wi-Fi
- Monitoring of distributed and large facilities with existing Wi-Fi infrastructure
- Configuration and data downloading via USB or Wi-Fi
- Alarm notification by email
- Wi-Fi data communication using NXperience, cloud systems, SCADA or NOVUS Cloud
- Modbus TCP and MQTT protocols
SKU: n/a
